Care and use of hoses
By following these simple tips you can ensure every hose has a long and productive life in the garden:
Our hoses are manufactured from premium grade PVC and can develop a memory which means they will try to reform the coil they have been shaped into during the packaging process. If this memory is not removed, it can cause knots and kinks to develop.
To do this:
1. Connect one end of the hose to the tap
2. Stretch the other end out from the tap preferably in a straight line
3. Close off the nozzle or gun on the end of the hose so water cannot escape
4. Turn on the tap and fill hose with water then turn off the tap
5. Leave the hose for up to 2 days (depending on weather conditions) in the sun filled with water
This should remove any memory from the hose and make it easier to handle. We recommend you store the hose either on a hose reel or in large loops on a hook.
Coiling a hose
Coiling a hose properly will prolong its life – and it’s simple to do:
1. Turn off the tap
2. Take hold of the hose a few metres from the tap connector
3. Bend a large loop, using about 1 metre of hose
4. Moving 30 – 40cm further away from the tap, form another loop and stack it on top of the first loop
5. Repeat until the entire hose is coiled
NB: We recommends the use of a hose reel or stowaway for proper storage of your hose and fittings.
Caring for hoses and fittings
Taking time to properly coil and uncoil a hose will not only extend its life but will ensure its original performance characteristics remain intact.
There are a few other steps which can also be taken to ensure you get the best
from the garden hose:
• Store hose out of direct sunlight when not in use to prevent sun damage and unnecessary wear
• Hoses should be stored indoors during freezing conditions for the same reason
• Never leave a hose under pressure when not in use (connected to a trigger gun or stop valve) and turn off the tap after each use to preserve the hose and conserve water
• Avoid running heavy objects over a hose, such as full wheel barrows or cars, as this could cause unnecessary damage
• Where possible pick up a hose and carry it rather than dragging it across concrete or around brickwork as this can create unnecessary wear and tear to the hose and its fittings
• Avoid contact with harsh chemicals and caustic substances as this could also damage the hose
• Do not drop the hose end with a trigger gun or fittings attached, on to concrete or other hard surfaces, as the impact could damage the fittings